- Plastic profile bars for light to medium loads. Assembly without screws.
- Available customized in 8 mm sections.
- Outside/inside: release by rotating 90°.
Stays on every 6th section, standard (HS: half-stayed)
Stays on every 3rd section (VS: fully-stayed)
The maximum cable diameter strongly depends on the bending radius and the desired cable type. Please contact us.
|42||60||66||68||76||84||92||100||108||116||124||132||140||148||156||164||172||180||188||196||204||212||220||228||236||244||252||260||268||276||Bi + 52||Bi + 56||1.16 – 1.54|
The divider system is mounted on each crossbar as a standard – on every 6th section for stay mounting (HS).
As a standard, dividers or the complete divider system (dividers with height separations) are movable in the cross section (version A).
For applications with lateral accelerations and applications with the cable carrier rotated by 90°, the dividers can easily be fixed by turning the frame stay by 180°. The arresting cams click into place in the locking grids in the crossbar (version B). The groove in the frame stay faces outwards.
The dividers can be moved within the cross section (version A) or fixed (version B).
The dividers can be moved in the cross section.
|A||11||16 / 42*||8||2|
* for aluminum partitions
The dividers are fixed with the partitions. The entire divider system can be moved in the cross section.
Aluminum partitions with 1 mm increments with ax > 42 mm are also available.
|ax (center distance of dividers) [mm]|
|ac (nominal width of inner chamber) [mm]|
When using plastic partitions with ax > 112 mm, we recommend an additional center support with a twin divider (ST = 4 mm). Twin dividers are also suitable for retrofitting in the partition system. The height separations VR4 and VR5 are not possible when using twin dividers.
Please state the designation of the divider system (TS0, TS1,...), version and number of dividers per cross section [nT ]. In addition, please also enter the chambers [K] from left to right, as well as the assembly distances [aT/ax] (as seen from the driver).
If using divider systems with height separation (TS1 – TS3), please also state the positions [e.g. VD23] viewed from the left driver belt. You are welcome to add a sketch to your order.
The universal end connectors (UMB) are made from plastic and can be mounted from the top, from the bottom or face on.
Recommended tightening torque: 10 Nm
F – fixed point
M – driver
U – universal end connector
We recommend the use of strain reliefs before driver and fixed point.